Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
187
Views
0
Helpful
2
Replies

Hunt Group Device Members not working

vwong
Level 1
Level 1

‎03-19-2003 12:21 PM - edited ‎03-12-2019 11:08 PM

I'm using CM 3.3(2) spB.

If I configure a hunt group with device member (username + line 1), it doesn't work. I confirmed that I logged in toi attendant console. But all I get is a busy. Anything obvious I may be missing? I can't find much to configure.

For a sanity check, i added a direct dial (partition + directory) to that same phone that I was logged in to. And that works fine.

Any ideas? Or obvious thing I'm missing?

Labels:
0 Helpful
2 Replies 2

adignan
Level 8
Level 8

‎03-19-2003 01:16 PM

Did you add the attendant console user and associate each member of the hunt group to that user?

0 Helpful

vwong
Level 1
Level 1
In response to adignan

‎03-19-2003 02:13 PM

Never mind. Operator Error. I didn't click the "go online" in attendant console. Problem fixed.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents