Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Hunt Groups and Extension Mobility

I'm having a problem with the way in which 3.1 (2c)handles extensions in hunt groups when they are logged out.

I have a hunt group (7899) containing 3 DN's 7900,7901 and 7902. If 7900 is logged in and 7899 is called, no problem 7900 rings. If 7900 is busy and 7901 logged in the 7901 rings. However if 7900 is logged out the call fails to re-order tone. I thought that the Cisco TCD was supposed to look at the state of the Line before attempting the call and step over unavailable/busy extensions.

Any thoughts anyone???

paul

2 REPLIES

Re: Hunt Groups and Extension Mobility

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: Hunt Groups and Extension Mobility

I have had a similar problem with hunt groups. The only way I could get around this was to forward the call on no answer for each user back onto the initial hunt group. This worked for longest idle hunt group pilot points.

243
Views
0
Helpful
2
Replies