Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

I cannot create route group in CCM 3.3 (4)

I want to create a route group in the CCM 3.3 but the gateways that have been configured doesn't appear (H.323) so they cannt be inserted in the route groups that I want to create.

I show some screen shoots for further explanation. Please help me

Thanks folks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: I cannot create route group in CCM 3.3 (4)

All h323 gateways show a status of unknown. that should be fine.

If you have already assigned the gateways to a route-pattern, you wont be able to add them in a route group.

What you can do is,

a. create a dummy h323 gateway.

b. during downtime window, repoint all RPatterns to this gateway.

c. create new route group/ route list and add the free'd up h323 gateways to this group.

d. repoint back all route patterns to this route-list.

HTH

Sankar

PLease rate all posts!

4 REPLIES
Green

Re: I cannot create route group in CCM 3.3 (4)

Does the GW is already assign to a Route Pattern?

New Member

Re: I cannot create route group in CCM 3.3 (4)

As my friend said... It is not possible to add a GW to router group but I think it is because there are a UNKNOW STATUS for each GW in List Gateways. (See Picture attached).

@gogasca

Hi, yes.. our two GW are being used 'cause they are assigned to a route pattern.

Re: I cannot create route group in CCM 3.3 (4)

All h323 gateways show a status of unknown. that should be fine.

If you have already assigned the gateways to a route-pattern, you wont be able to add them in a route group.

What you can do is,

a. create a dummy h323 gateway.

b. during downtime window, repoint all RPatterns to this gateway.

c. create new route group/ route list and add the free'd up h323 gateways to this group.

d. repoint back all route patterns to this route-list.

HTH

Sankar

PLease rate all posts!

New Member

Re: I cannot create route group in CCM 3.3 (4)

your recommendations helped me to solve part of the problem.

I am sending a new case, I wait you help me to complete the scenario

thank you

107
Views
0
Helpful
4
Replies