Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
eku
New Member

I cannot find NM-HD-2V in CM 3.3(3)

Dear all,

I installed a nm-hd-2v in my client's 3745 router, running 12.2(15)zj IP plus software. I want to use it with CM 3.3(3) in MGCP, but I just cannot find any NM-HD-2V module in the 3700 category in the CM. I have installed a VIC-4FXS/DID, and of course, I can't find it either in the CM.

Anyone got an idea?

2 ACCEPTED SOLUTIONS

Accepted Solutions
New Member

Re: I cannot find NM-HD-2V in CM 3.3(3)

Have you installed the Gateway for the 3745?

Once the Gateway is installed, You should be able to select the appropriate device in Slot 1-4.

I am running 3.3(3) with the same router and the options for the NM-HD-2V is an option. Then you select the card type that is installed in Subunit.

New Member

Re: I cannot find NM-HD-2V in CM 3.3(3)

Try 3.3(3)sr2

2 REPLIES
New Member

Re: I cannot find NM-HD-2V in CM 3.3(3)

Have you installed the Gateway for the 3745?

Once the Gateway is installed, You should be able to select the appropriate device in Slot 1-4.

I am running 3.3(3) with the same router and the options for the NM-HD-2V is an option. Then you select the card type that is installed in Subunit.

New Member

Re: I cannot find NM-HD-2V in CM 3.3(3)

Try 3.3(3)sr2

82
Views
0
Helpful
2
Replies
CreatePlease to create content