For each of these, create a route pattern 9.@ with the associated route filter, configured to 'Block this Pattern'.
411 route filter: (SERVICE == 411)
Caribbean #s: (AREA-CODE == XXX) OR (AREA-CODE == YYY). Add as many OR elements as have area codes you want to block. There is a limit on the size of route filters, so you'll only be able to pack in around ten area code clauses. Add more route filters and route patterns if you need more. There's a good list of "suspect" prefixes in the book 'Troubleshooting Cisco IP Telephony' from http://www.ciscopress.com , ISBN 1-58705-075-7.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.