I need to monitor the status of an analog phone connected to an ATA 186
I have analog phones connected to an ATA 186.
My client needs to have monitored the status of this phones. They have the IP Telephony Monitor and as the ATA doesn´t have SNMP support I can´t receive any trap from them. But is there any way to have monitored the status (registered...) of those analog phones? Would the IP Phone reachability testing give me some information of these phones?And the IP Phone Information Utility?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...