I have CallManager 3.2, Unity 3.1, and IAD2400's running 12.2-8T. The Unity will light the MWI on the IP phones we have, but we have no stutter dial-tone on the analogs coming off the IAS2400. I'm using MGCP 0.1 between the CM and IAD's. CCO mentions stutter dial tone on the IAD's using xGCP, but I haven't found the doc that tells me if I need to configure it some where or if it should just work.
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
The IAD2400 will not support stutter dial tone. We had to move to VG248 to make this and other analog functions work. This is an issue with the IADs and not the CallManager or the Unity. That's the response that we got from TAC.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.