Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IC7750 MRP300 E1 MGCP

I am trying to configure CCM and an MRP300 with MGCP. I setup the gateway and looking at the MRP it is registered and talking to CCM. CCM shows the IP address of the MRP but says it is unregistered. The MRP shows no endpoints registered and show mgcp statistics shows AuditConnection failed increasing in value.

1 REPLY
Silver

Re: IC7750 MRP300 E1 MGCP

I heard that 12.2(8)YN may be too old for CallManager 3.3 with MGCP and may cause problems, you can go for 12.2(13)ZH.

http://www.cisco.com/en/US/products/hw/voiceapp/ps967/products_installation_and_configuration_guide_chapter09186a0080121964.html

127
Views
0
Helpful
1
Replies
CreatePlease to create content