I just wondering if anyone knows what the expected outcome would be for the following test on an ICM 5.0 system..
If I run status on RTTEST to see which side is active as indicated by the Router synch line ie. (A->B). I then pull the Visible cable from the Active side (Private link between Roggers is still up). On the PG's, pgagent shows the following:
16:35:03 pg1A-pgag Connection to Central Controller side A failed (high priority).
Last EMT Error : EnterpriseAgent PIM
16:35:03 pg1A-pgag Path to Central Controller side A disconnected.
16:35:03 pg1A-pgag Attempting to realign message stream with Central Controller side B.
16:35:03 pg1A-pgag Path to Central Controller side B is now active after successful realignment
The question is if I run status on RTTEST, should the Router Sync line reflect that the other server is active ie (B->A)
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...