I have an ICS7750 with FXO to a co. The MRP is defined as an h323 gateway and all ports are plared to a 7960 in the office. Having problems with 7960 phone ringing when no one is on the other end of the line. I've tried connection plar opx and that does help. Any suggestions??
A similar problem is discussed in the following bug where there are Calls through MRP from PSTN to IP phone.One of the reason behind it is, when a call is connected and completed, the on-hook status signal doesnot reach the IP Phone and hence, the call rings back.When answered, it will result in dead air. This might be a problem with the ICS7700 as noticed in the bug below.
CSCdv48803 .For more details on this bug refer the url :
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...