Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

ICS7750 spe card rebuild. (core software)

We are rebuilding an SPE card that has gone down. We have successfully rebuilt the card with the windows 2000 image. However we would now like to put core software on it without affecting the other SPE cards that are up and working. Could someone point me in the correct direction for this.

Is there software we can load straight onto the card. Rather than running from the CD on a remote PC attached to the main switch?

We have upgraded to System Manager 2.5 - any replies would be very welcome.

Thanks Mark Wright.

2 REPLIES
Anonymous
N/A

Re: ICS7750 spe card rebuild. (core software)

Here is a very good document on the step by step procedure of reimaging the SPE card. It is given below:

Cisco ICS 7700 Series Integrated Communication Systems

Reimaging Instructions for SPE310 Cards on the Cisco ICS 7750, 2.3.0

http://www.cisco.com/en/US/products/hw/voiceapp/ps967/prod_maintenance_guide09186a00800a9338.html

Hope this helps.

New Member

Re: ICS7750 spe card rebuild. (core software)

Thanks very much for your reply.

Regards Mark.

117
Views
0
Helpful
2
Replies
CreatePlease to create content