Apparently the Idle URL is supported on CP7911G, but are the specs for the xml/asp-file the same as for the CP7940/60? I have trouble to load such an url on a 7911 while it works fine on the 7940/7960.
I just attempted this without success. I placed the same image in both subdirectories off the TFTPPath and it worked on the 7914 but not on the 7940/60. It seems the 7940/60 did not like the image size. I had to size each individually in an image editor to allow the graphic to render on the different size IP phone screens.
Depth is set to 2 in your file. Try changing it to 1.
If that is not successful covert your image file to a .png and use the thumbnail (named TN-logo.png) and full image (named logo.png) as stated in the design doc. The xml file will need to contain the menu, like this:
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...