Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

if I use blast option in zone prefix command

Hi,

I would like to introduce in our network the remote zone gatekeeper redundancy.

I saw there' s a "blast" option in zone prefix command.

Could I use that without problems?

Thanks.

Regards, Paolo

1 ACCEPTED SOLUTION

Accepted Solutions
Green

Re: if I use blast option in zone prefix command

By default, LRQs are sent sequentially to the remote gatekeepers. With sequential, the LRQs are sent one at a time with a delay between each. With blast, the LRQs are sent back-to-back in a rapid sequence without any delay between them. If you would like the LRQs to be sent simultaneously (blast) to each gatekeeper, you need only specify the blast keyword on one zone prefix command per E.164 prefix

1 REPLY
Green

Re: if I use blast option in zone prefix command

By default, LRQs are sent sequentially to the remote gatekeepers. With sequential, the LRQs are sent one at a time with a delay between each. With blast, the LRQs are sent back-to-back in a rapid sequence without any delay between them. If you would like the LRQs to be sent simultaneously (blast) to each gatekeeper, you need only specify the blast keyword on one zone prefix command per E.164 prefix

234
Views
0
Helpful
1
Replies
CreatePlease login to create content