I would like to implement IVR in my AS5300 using the clid_authen_collect.tcl script. I have a RADIUS server which will authenticate the users. I would like to know if the user info I will use (user file) is correct. For example the ani is 123456 and the password is 123456 is this user info correct to set in the user file:
123456 Password "123456"
Service-Type = Framed-User,
Framed-Protocol = PPP,
If somebody had any previus experience with TCL IVR scripts and a Linux/Unix based RADIUS server please I would like to know about your implementation. and how to set the user file.
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.