IMS Conncector in Exchange 5.5 (Not the Same Site)
CCM 3.2 (2C)
Just want to be clear on this before I go ahead and do it.
I have two unity servers in diffrent Exchange 5.5 sites. I want to network these servers via dialing domains. According to the documentation You need to install the IMS service on both Unity servers and then install the voice connector. This all sounds good.
What I am looking for is documentation that tells you the recommended procedure to config the IMS service. I have read the documentation on the voice connector. I just want to be certain that I config the IMS service right.
Re: IMS Conncector in Exchange 5.5 (Not the Same Site)
Possibly it's a security issue. That is, the account that you are logged on as does not have access to that part of the Registry. Try logging on with another account that has more rights/permissions on the server and see if that makes a difference.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.