I have several fxo-loop-start channels on a T1 that I have confiugred as separate DS0 groups. I need to configure incoming calls on these groups to go to specific DNs. I have tried to set a destination pattern on the voip dial peer, but with no success. This is an H.323 gateway. Can someone help, please?
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4