Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

incoming call config on VIC2-2BRI-NT/TE

ive installed VIC2-2BRI-NT/TE module on my voice gateway where my cme/cue resides.

OBJECTIVE;

-Incoming call will connect directly to an extension 100 but after 5 rings is finished, then it shoud procced to the cue auto attendant 101.

Anyone help me for the configuration please

3 REPLIES
Hall of Fame Super Gold

Re: incoming call config on VIC2-2BRI-NT/TE

voice-port x/y/z

connection plar 100

ephone-dn 100 dual-line

number 100

call-forward noan 101 timeout 30

You can simplify configuration by placing common call forward settings under an ephone-dn-template, and apply the latter to all or groups of ephone-dn's.

Hope this helps, please rate post if it does

New Member

Re: incoming call config on VIC2-2BRI-NT/TE

what about the isdn part..

Hall of Fame Super Gold

Re: incoming call config on VIC2-2BRI-NT/TE

Only define tei-static 0 if necessary. All rest is default.

135
Views
4
Helpful
3
Replies
CreatePlease login to create content