incoming call config on VIC2-2BRI-NT/TE

[cfajardo1_2]

ive installed VIC2-2BRI-NT/TE module on my voice gateway where my cme/cue resides.

OBJECTIVE;

-Incoming call will connect directly to an extension 100 but after 5 rings is finished, then it shoud procced to the cue auto attendant 101.

Anyone help me for the configuration please

[paolo bevilacqua]

voice-port x/y/z

connection plar 100

ephone-dn 100 dual-line

number 100

call-forward noan 101 timeout 30

You can simplify configuration by placing common call forward settings under an ephone-dn-template, and apply the latter to all or groups of ephone-dn's.

Hope this helps, please rate post if it does

[cfajardo1_2]

what about the isdn part..

[paolo bevilacqua]

Only define tei-static 0 if necessary. All rest is default.