cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
166
Views
0
Helpful
1
Replies

Increase timeout after message

sarrick
Level 1
Level 1

Is it possible to increase the timeout after leaving a message. Right now, it seems the system waits about 2 seconds of silence before it executes the "after message - say goodbye" call handler. Is it possible to increase that to say 4 seconds? Thanks again.

1 Reply 1

lindborg
Cisco Employee
Cisco Employee

On the System | Configuration page in the SA, go to the "Recordings" section and you'll see two settings for "Stop recording after how many seconds" - that should actually say "Stop recording after how many seconds of silence" but hey...

By default short messages (those less than 10 seconds) wait for 2 seconds of silence before timing out. Longer messages wait 3 seconds. You can adjust those settings here but be careful - if you crank them up too far folks will have to wait a long time for the recording to terminate... 3 seconds of silence is a pretty long time over the phone.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: