Quick question regarding port settings on a 4006 48port inline power blade. Should the ports be set to trunk auto or trunk off? The phones seem to function either way but I'd like to know which is correct.
You don't need to configure trunking on the ports. If there will be an IP phone connected and you want the voice to use one VLAN and a PC connected to the phone to use a different VLAN, you would configure this by using set port auxiliaryvlanx where x is the desired voice vlan to be used. See:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...