Here is what I normally due for a blank 7835 Unity install.
1) Boot from Compaq SmartStart CD and configure the system partition, Drive setup (RAID 1).
2) I create a 8Gb partition for system, 4 Gb partition for log files and a 4Gb partition for data (mailstore, only if mailboxes are stored somewhere else. If they are going to be stored locally, like a POV system, I'll increase the data partition.)
If you need more info on going through the Compaq Smartstart, send me an email directly.
separating your store and log files in exchange 2000 is a great idea for hard disk input output perfromance and for fault tolerance however putting them on different partitions does nothing unless on they are on seperate physical disks.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...