After unity installs, you are told to run the configuration setup from the icon on the desktop. During this setup, it asks you for the password of the user you are logged in as, in my case, administrator. It keeps bouncing back saying invalid password. I've created a new user with admin rights, and tried that, same problem. As well as change the password for admin, again, same problem. Suggestions? <br><br><br><br>
Does the account you are logged in as have 'Act as part of the OS' and 'Log on as a service' rights effective?
Here is the release note for defect CSCdv37418 - it addresses this issue.
Symptom: During Setup Part II, the correct password for the account installing Unity is not accepted.
Conditions: this only occurs in Unity 3.0
Workaround: Give the installation account 'act as part of the operating system' and 'log on as a service' effective rights on the Unity server. Right click on Security Settings and choose Reload to force the changes to take effect. Verify that these rights are effective (not just at the local level). Then re-run Setup Part II. This may require a server reboot, even if the policies appear to have taken effect.
In order to make these rights effective on the Unity server: if Unity is a member server, it should be sufficient to grant these rights in the Local Group Policy. If Unity is a domain controller, you will need to add these rights to Default Domain Controller Policy.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...