Installing SRST!

asapun · ‎07-30-2002

I can't seam to figure out how to eable SRST on my gateway!

I have IOS Version 12.2(10b). Do I need to get anything esle?!

Pls some help on this.

Thanks in advance..

Vance Krier · ‎07-30-2002

Load 12.2.8T IPPlus...

Good luck,

Vance

s-cortes · ‎07-31-2002

I have tried 12.2(2)XT Enterprise plus/H323 MCM. I works fine. Just check your flash and DRAM for the recommended size.

Good Luck.

michaelschulz · ‎08-01-2002

Not every image supports SRST or ITS (look at the Cisco information sheets).

Attention SRST will allways run if you have the ip-phones in the same subnet and the SRST-Router is the default-gateway for the phones.

Nice day to you.

Michael

asapun · ‎08-02-2002

IP Phones are in the same subnet, but not int the same subnet with the G/W.

and

do I need to get some kind of activation code to be able to activate SRST or is it just a piece of paper with a license?

Thanks

jpstott · ‎08-02-2002

The phone must be on the same subnet as the gateway (i.e. the SRST device must be the phones' default router). What type of gateway are you using? A router with a spare ethernet port would do the trick. Even if you don't want to use the SRST device as your default gateway, you could use HSRP with SRST.

You need to purchase a license from your reseller to use this feature.