I am at the point of installing Unity however the install does not detect the system key. I have deleted the Windows 2000 driver and installed the Unity driver on Disk 1 for the USB port. The key is attached to the system. Device Manager says under Rainbow USB SuperPro "Your registry might be corrupted (Code 19). I have deleted the driver and reloaded with the same result. Any help would be appreciated.<br><br>
If that doesn't work, I had a similar issue where I could not get the system to read the system key on any USB port and had to install the system in Demo mode then, using the Upgrade License utility, go in after the fact and add/upgrade my license.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.