Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Intecom E14 T1 line code documentation error?

The Intecom E14 Millennium Serial Integration manual reads:

Step 5 Configure the T1 cards to be connected to Cisco Unity for the following:

• Internal clocking

• B8ZE line coding

• D4 framing

Our PBX guys are asking if the "B8ZE" is a typo? BEZs and B8Zs are what they are aware of.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Intecom E14 T1 line code documentation error?

This is a typo. The integration guide should state B8ZS. I've already alerted our Tech Pubs. Thanks for the catch.

2 REPLIES
Cisco Employee

Re: Intecom E14 T1 line code documentation error?

This is a typo. The integration guide should state B8ZS. I've already alerted our Tech Pubs. Thanks for the catch.

New Member

Re: Intecom E14 T1 line code documentation error?

As it turns out. The Dialogic card use AMI line coding and not B8ZS. The Intecom switch T1 should be programmed to use AMI line coding.

If you use the Dialogic 240PCI/T1 and use B8ZS line coding you will have port lockups which eventually bring down the whole T1.

96
Views
0
Helpful
2
Replies
CreatePlease to create content