Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Integrating FXO With Nortel FXS Interface...

Hi,

I have Cisco1760-V Routers with Vic2-2FXO cards on both ends connected on the FXS Interface of the Nortel PABX, when i dial the extension No. on which my router is connected i am getting the tone but when i dial the extensions for the connected branches the dialtone is not getting cut. I am not able to reach any of the branches. do i need any specific configurations on my PABX or the Voice Interface to relay this digits to the router.

1 REPLY
Bronze
126
Views
0
Helpful
1
Replies
CreatePlease to create content