Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Integration between Call Manager Express and Nortel BCM

What type of integration is there between a BCM 1000 or 50 and CME and Unity Express? Can we setup 4 digit dialing using h.323? We are placing a CME router at a remote site that is connected via PPP T1 into the main office which has a Nortel BCM 1000 running 3.6.

Any assistance is greatly appreciated!

Thank you,

Jesse Pike

4 REPLIES
Silver

Re: Integration between Call Manager Express and Nortel BCM

Before doing the following tasks to integrate Cisco Unity with the Nortel Meridian/PBXLink phone system, confirm that the Cisco Unity server is ready for the integration by completing the applicable tasks in the applicable Cisco Unity installation guide.

The following task lists describe the process for creating, changing, and deleting integrations.

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/prod_configuration_guide09186a00801171e4.html

New Member

Re: Integration between Call Manager Express and Nortel BCM

Hello - The link is no longer available.

New Member

Re: Integration between Call Manager Express and Nortel BCM

Were you able to make this integration work? I have a customer that is wanting to setup the same type of integration and have been looking for information.

Thanks,

Robert Bailey

New Member

Re: Integration between Call Manager Express and Nortel BCM

We were able to get this setup with the assistance of Nortel. Here are the requirements on the BCM in addition to the configurations for CME (probably similar for CM).

In a nutshell you need at least 3.6 running on the BCM

Nortel BCM 1000 attributes:

BCM 3.6 2.2c

Load these patches in order on the BCM

BCM_360[1].236_FEPS.33.371600.exe

BCM_360[1].259_CUMULATIVE.99.3.exe

BCM_360[1].252_CORE.08.0621.exe

Make sure calls are made through destinations codes and not access codes Under destination codes absorbed all Enable H245 Disable and enable the H323 VoIP gateway

Cisco IOS version 12.4.4XC using CME 4.0.1 Ensure voice service's on the router are as follows:

voice call send-alert

!

voice service voip

allow-connections h323 to sip

fax protocol pass-through g711ulaw

h323

modem passthrough nse codec g711ulaw

!

voice class codec 1

codec preference 1 g711ulaw

!

voice class h323 1

h225 timeout tcp establish 3

call start slow

call preserve

1249
Views
1
Helpful
4
Replies
CreatePlease to create content