Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Integration between Cisco VOice gateway & Ericcsion MD110 EPBX

Hi

Need to know what parameters needs to match in between Cisco VG & Ericcsion PBX while integration(india off is going to connect through MPLS link(E1) via VG to US, in US we have avaya PBX)

We have a E1 connection (trunk) between VG & PBX.

Also need physical connectivity details like cross or stratght cable details.

Send important doc link also

Regards

Naga.

1 REPLY
Hall of Fame Super Gold

Re: Integration between Cisco VOice gateway & Ericcsion MD110 EP

Hello,

the pinout for the router is documented at at:

http://cisco.com/en/US/products/hw/modules/ps2641/products_module_installation_guide_chapter09186a008007cb4c.html

You will need to configure both PBXs for ISDN PRI as described at;

http://cisco.com/en/US/partner/products/ps6350/products_configuration_guide_chapter09186a00800ca716.html

Note the correct command is "isdn incoming-voice voice" and not "modem" as the documentetion wrong in this.

Hope this helps, please rate post if it does!

120
Views
0
Helpful
1
Replies