inter cluster trunk/ ip to ip communication with remote office without ccm
We've both ipipgateway configured to communicate with each other. Attachment pngipipgw1 is our local voice router with destination pattern 3XXXX that need to link with other country Japan with destination pattern 7xxxx . All other country locations is ok except the japan which are using non cisco callmanager to link to our local site with cisco call manager 4.1(3) with destination pattern 3XXXX.
Q1.) Based on the ipipgateway configurations of both parties, please advise any finding/thoughts?
Q2.)At our local site, We have nm-hdv with 2 pvdm simm that configured as dspfarm transcoder. Is it enough to have only 2 pvdm simm out of 5 in the nm-hdv? If we add in new pvdm, do we need any configuration at the voice gateway or we just plug in the hardware?
Re: inter cluster trunk/ ip to ip communication with remote offi
Q1. Could you explain a little more about what is the problem you have with the calls between those two sites? Please share which number on one side is calling which other number on the other side and what happens with the call.
Q2. It depends on how are you using your Xcoder resources. If some of your conferences or calls are being terminated because you are running out of resources, it will be advisable to add some more pvdm2 to your router. Also after adding the hardware, you would like to change the configuration to increas the maximum number of transcoding sessions.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.