Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Intercom with CME

Hello guys,

Is there anyway to configure Intercom with CME? If so, could you please send me some config examples?

Thanks,

2 REPLIES
Hall of Fame Super Red

Re: Intercom with CME

Hi Bahman,

It is possible to set up intercom in CME, have a look at the following notes;

intercom (ephone-dn)

To create an intercom by programming a pair of extensions (ephone-dns) to automatically call and answer each other, use the intercom command in ephone-dn configuration mode. To remove an intercom, use the no form of this command.

intercom extension-number [barge-in [no-mute] [label label] ] [ no-auto-answer] [label label] [no-mute]

no intercom extension-number

Syntax Description

extension-number

Telephone number to which intercom calls are placed.

barge-in

(Optional) Allows inbound intercom calls to force an existing call into the call-hold state and allows the intercom call to be answered immediately.

label label

(Optional) Defines an alphanumeric label for the intercom, of up to 30 characters.

no-auto-answer

(Optional) Disables the intercom auto-answer feature.

no-mute

Allows an intercom call to be answered without deactivating a speaker's mute key.

Defaults

Intercom functionality is disabled.

From this doc for CME 4.0;

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_command_reference_chapter09186a0080611355.html#wp1050890

Hope this helps!

Rob

Please remember to rate helpful posts.....

Re: Intercom with CME

Also,

Its generally recommended to use numbers like A001 or A002 as the intercom DNs so that these numbers are not dialable from an ip phone or from outside

450
Views
4
Helpful
2
Replies
CreatePlease to create content