Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

interdigit timeout in CM 3.1

I must change the interdigit timeout in a CM 3.1.

I have used this service parameter in version 3.0(8), but I can not find it in this new version.

1 REPLY
New Member

Re: interdigit timeout in CM 3.1

Change the value of the following CallManager service parameter:

TimerT302_msec

This is normally set to 10000ms

Hope this helps.

Justin

98
Views
0
Helpful
1
Replies
CreatePlease to create content