Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

international calling

having issue with international dialing from a cme:

Called Party Number i = 0xA1, '01161396694916'

Plan:ISDN, Type:National

carrier is expecting the called party type to be international. so I set a translation:

........

voice translation-rule 10

rule 1 // // type national unknown

!

!

voice translation-profile internat

translate called 1

!

!

........

and applied it to my dial-peer (actually, as you can see i have thrown the kitchen sink at it)

..........

dial-peer voice 5 pots

description ** T1 PRI pots dial-peer **

translation-profile outgoing internat

destination-pattern 9011.T

translate-outgoing called 10

port 0/0/0:23

prefix 011

!

no effect at all. funny thing is when i csim start the call from the router it goes out as called party type unknown and actually works! not sure why the difference in the type from an ip phone on the cme versus the actual router via a csim, but that might be a whole nother conversation out here.

any help will be greatly appreciated!

  • Other Collaboration Voice and Video Subjects
6 REPLIES

Re: international calling

Test your translation rule to see if you are getting the required digits (called number).

Check the syntax on this one.

test translation-rule blah blah...( from privilege mode)

New Member

Re: international calling

unless i am way off base here i think i am on the right path:

bnerouter_cme#test voice translation-rule 10 901155512345 type national

Matched with rule 1

Original number: 901155512345 Translated number: 901155512345

Original number type: national Translated number type: unknown

Original number plan: none Translated number plan: none

New Member

Re: international calling

just got off phone with tac. my issue was my inability to type - my config should have looked like this:

voice translation-rule 10

rule 1 // // type any unknown plan any unknown

!

!

voice translation-profile internat

translate called 10

my issue was under the profile i had set translate called to 1 instead of 10.

oops. works like a charm.

thanks for the post!

New Member

Re: international calling

Jim,

This problem of yours helped me out. Is there any good documentation on translation rule syntax. I assume what yours is doing is changing type any to type unknown and plan any to plan unknown.What are the beginning // // Is that where to search in a string?

Thx

Re: international calling

I think EPABX Calling

I think EPABX Calling Solutions will be beneficial for you on international calling. This feature allows your users to enjoy international business calling from any configured office desk phone with just their PINs. I have been using this feature from Reliance Global Call & also reducing our monthly bills. 

300
Views
0
Helpful
6
Replies
This widget could not be displayed.