Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

international calls fail

I have a customer who has CM 3.33sp4a, H232 gateway with a T1 for LD. The dial pattern 9.011XXXXXXXXXXXX

and the following dial peer

dial-peer voice 9011 pots

destination-pattern 9011............

port 1/0:1

prefix 011

When the call gets placed it rings then a recording comes on call can't be completed.

When I do a SH VOICE CALL STAT on the router it shows

0x1C0C2 151D 0x81B2AE64 1/0:1.20 8/4 *0396980059 g711ulaw 0/9011

debug out showes that it can't find prefix for DP

Mar 1 19:59:55: //114540/xxxxxxxxxxxx/CCAPI/cc_api_call_disconnect_done:

Mar 1 19:59:55: cannot find prefix for dp 9011 called number 9011390396980059

Mar 1 19:59:55: //114540/80A70910A201/CCAPI/cc_delete_call_entry: not incoming

entry

Mar 1 19:59:55: //114540/80A70910A201/CCAPI/cc_delete_call_entry: entry's incom

ing FALSE.

Mar 1 19:59:55: //114540/80A70910A201/CCAPI/cc_delete_call_entry: is_incoming i

s FALSE

Mar 1 19:59:55: //114540/80A70910A201/CCAPI/cc_delete_call_entry: Deleting prof

ileTable[0x81DE2598]

1 REPLY
Bronze

Re: international calls fail

I would first change the dial-peer number. Make it something in the 90-99 range. I know this can cause problems. Why don't you just use the route pattern in CCM and not make a specific dial-peer. It should pick up the default dial-peer that you have for the location.

Geoff

103
Views
0
Helpful
1
Replies
CreatePlease to create content