Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

international translation pattern

Would like to create a "speed dial" using a translation pattern. The TP is *14 mask 011123456789. this will match a 9.@ route pattern. We have to use the 9.@ because we are using an AT&T 4ESS PRI with the PreDot IntlAccess IntlDirectDial discard digit instruction. We we just try to dial the number the call will wait for the timeout and the call will go through. When we use the *14 translation pattern we hear 10 seconds of dial tone then the call goes through. why am i hearing dial tone?

1 REPLY
New Member

Re: international translation pattern

Sorry to think it is so simple but just in case. Did you check "Provide outside dial tone" on the TP page?

156
Views
0
Helpful
1
Replies