Do I need to be licenced to use this feature. In other words in Dumpkey should I see something with that reference. Any docs available in regard to installation of the gateway....<br>Thanx <br><br>Sean Poure<br>NEC-Voice Engineering<br>Sr. Systems Engineer<br>714 4846275<br>
There's not much to know about installing the IVC... I believe the System Administration guide networking chapter talks a little about it, but I don't have it in front of me. You just need to install it on the Exchange server in the site that has the IMC installed on it (i.e. the SMTP gateway server). Once it's installed, there's nothing to configure... it's an on/off kinda thing.
The System Admin guide talks about how to use the extension address utility and do blind addressing etc... which require the IVC to be installed and in place.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...