Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

intregation PBX with 2811

Greetings,

first the scenario, i have one DX Quitum with E1 interface and Samsumg iDCS with TEPRI card for pbx to E1 convertion.

We have purchased 1 2811 with VWIC-2MFT-E1, NM-PVDM2 64 and planning to buy CallManager 4.1.

I want to intregate iDCS with 2811 and use the router as transcorder+gateway, i need to terminate outbound calls and well as receive inbound calls from US and UK DIDs i have.

Can i create dial-peer gorups ? for certain inbound numbers?

Please suggest if its better to use 2811 as gateway for termination aswell as inbound or should i use CCM.

what IOS i need for 2811 to act as gateway for both SIP & H323 calls.

i'm new to cisco solution so please excuse me if it sounds stupid Q.

1 REPLY
New Member

Re: intregation PBX with 2811

Yes, Dial groups are the best bet.

96
Views
0
Helpful
1
Replies
CreatePlease login to create content