Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IOS bug in SIP call setup: Non-incrementing CSeq header field value

We encountered an issue with our Cisco 2621 GW in call set-up with some SIP phones and SIP servers. The Cisco sends problematic re-invite messages which doesn't get any positive response to it because the Cisco does not increase the CSeq header value in the re-INVITE messages !

does anyone know how to resolve the issue of in Cisco? Maybe we should use a different version of IOS.

Here is the “sh ver” output of our GW:

Cisco IOS Software, C2600 Software (C2600-SPSERVICESK9-M), Version 12.3(14)T7, RELEASE SOFTWARE (fc2)

ROM: System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE (fc1)

System image file is "flash:c2600-spservicesk9-mz.123-14.T7.bin"

Cisco 2621XM (MPC860P) processor (revision 0x401) with 125770K/5302K bytes of memory.

Processor board ID FCZ093670YT (3282082554)

M860 processor: part number 5, mask 2

2 FastEthernet interfaces

31 Serial interfaces

1 Channelized E1/PRI port

32K bytes of NVRAM.

49152K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

1 REPLY
Hall of Fame Super Gold

Re: IOS bug in SIP call setup: Non-incrementing CSeq header fiel

hi,

you should try if it happens with latest 12.4 as well.

If it does, you need to seek help from the tac in case a bug nedd to be located or filed as new.

Hope this helps, please rate post if it does!

230
Views
0
Helpful
1
Replies