Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IOS Code too Use; CME

Running a 2621XM, 12.4.4T, CME 3.4, two port FXO and 2 port FXS.

I have static on all calls when I speak into the reciever. Other end is very clear and they do not hear static.

Is there a solid IOS version and CME version to run that is fairly bug free?

DSP DSP DSPWARE CURR BOOT PAK TX/RX

TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT

==== === == ======== ======= ===== ======= === == ========= == ===== ============

C542 001 01 None 6.3.2 IDLE idle 0 0 1/0/0 NA 0 844/868

C542 002 01 None 6.3.2 IDLE idle 0 0 1/0/1 NA 0 596/593

C542 003 01 None 6.3.2 IDLE idle 0 0 1/1/0 NA 0 1331114/1332

915

C542 004 01 None 6.3.2 IDLE idle 0 0 1/1/1 NA 0 41235/41926

edsp 001 01 g711ulaw 0.1 IDLE 50/0/1.1

edsp 002 01 g711ulaw 0.1 IDLE 50/0/2.1

edsp 003 01 g729r8 p 0.1 IDLE 50/0/3.1

edsp 004 01 g711ulaw 0.1 IDLE 50/0/4.1

edsp 005 01 g711ulaw 0.1 IDLE 50/0/5.1

edsp 006 01 g729r8 p 0.1 IDLE 50/0/6.1

edsp 007 01 g711ulaw 0.1 IDLE 50/0/7.1

edsp 008 02 g711ulaw 0.1 IDLE 50/0/7.2

edsp 009 01 g729r8 p 0.1 IDLE 50/0/8.1

1 REPLY
pfh
New Member

Re: IOS Code too Use; CME

I've had the best luck with CME 3.3 on 12.3(14)T6. Lacks some of the newer features, but seems to be less bug-ridden.

Also, I recommend using only the phone load that comes with the specific CME distribution. It seems I always get burned when I deviate from that.

88
Views
0
Helpful
1
Replies