Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IOS DSP ressources with Sub-if

Hi all,

i've got a router with only on ethernet and 2 sub-if. i would like to use the NM-HDV DSP for conferencing in CCM.

Is it possible to bind sccp local to on of the sub-if?

I already tried but it seems not to register to CCM.

Have someone already done this?

thank you

  • Other Collaboration Voice and Video Subjects
2 REPLIES
Cisco Employee

Re: IOS DSP ressources with Sub-if

Yes you should be able to register it to the sub interface. The MAC address used is the same. Also, since SCCP connections are initiated by the end point (in this case, the router), you should be fine.

Check configs. Post them.

Then, do a

conf t

no sccp.

do debug sccp packet

sccp

Then, send the debugs to us. Thanks!

New Member

Re: IOS DSP ressources with Sub-if

i apologies, i done a mistake in the CCM configuration.

Are you Voice CCIE?

97
Views
0
Helpful
2
Replies
This widget could not be displayed.