Voip Network: PBX connected to Cisco3800 using NMHDV; router working as voice gateway.
When my extenion makes call thru Cisco, router sends the actual CLI (043664741)to other h323 router. I want this 'specific' CLI to be translated to another series 08718553333.
i have to use translation rule or profiles...but some how it is not working.. any help..
Please paste your configs.
You could use a combination of a translation rule and a translation profile which then is applied to a dial peer, such as:
voice translation-rule 3
rule 1 /043664741/ /08718553333/
voice translation-profile profile1
translate calling 3
dial-peer voice 10 pots
translation-profile outgoing profile1
Voice Translation Rules
Hope this helps. If so, please rate the post.
since its for out going calls, i guess should apply translation-profile outgoing profile1 on the 'voip dial peer' am i correct..
though i did that and tested stll translation wasnt happening place.
i am posting the config attached.
The translation rule looks good. Apply it to the dial-peer, as below
dial-peer voice 1000 voip
translation-profile outgoing skyi