Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IOS onramp faxing with CCM

Hi,

I need to beak out fax calls which are received through an MGCP gateway (e1) to a router which is running the IOS fax onramp TCL script.

I was going to configure a route pattern in CCM for my 2 fax numbers & point these to the TCL router.

Then my calls would come through my MGCP gateway & get passed off to the IOS router.

My concern is that I won't have any POTS dial peers on the IOS gateway - will this work & if so do I need ip / ip gateway feature set ?

Thanks for any help,

Paul.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: IOS onramp faxing with CCM

For onramp/offramp, the call has to come in via a POTS leg. It doesn't work if the call comes in via VoIP. The router basically wants to negotiate with the remote fax machine via a POTS leg.

2 REPLIES
Cisco Employee

Re: IOS onramp faxing with CCM

For onramp/offramp, the call has to come in via a POTS leg. It doesn't work if the call comes in via VoIP. The router basically wants to negotiate with the remote fax machine via a POTS leg.

New Member

Re: IOS onramp faxing with CCM

Thanks markus.

133
Views
0
Helpful
2
Replies
CreatePlease to create content