Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IOS transcoder/conferense bridge will not register with CCM

I have configured a VG200 with a NM-HDV module installed. My Vg200 config looks good. I added the transcoder and conference bridge into CCM (3.32).

But when i do a sh SCCP in the VG200 It shows the following cause code

Gateway IP Address: 10.2.1.9

Switchover Method: IMMEDIATE, Switchback Method: GUARD_TIMER

Switchback Guard Timer: 1200 sec, IP Precedence: 5

Max Supported MTP sessions: 0

User Masked Codec list: None

Transcoding Oper State: DOWN - Cause Code: NOT_REGIS_WITH_CCM

Active Call Manager: 10.2.1.6, Port Number: 2000

TCP Link Status: CONNECTED

Conferencing Oper State: DOWN - Cause Code: NOT_REGIS_WITH_CCM

Active Call Manager: 10.2.1.6, Port Number: 2000

TCP Link Status: CONNECTED

Call Manager: 10.2.1.5, Port Number: 2000

Priority: 1, Version: 3.1 or Higher

Call Manager: 10.2.1.6, Port Number: 2000

Priority: 2, Version: 3.1 or Higher

  • Other Collaboration Voice and Video Subjects
2 REPLIES
Bronze

Re: IOS transcoder/conferense bridge will not register with CCM

Make sure you have CFB and MTP in front of the MAC address of your device in ccmadmin.

New Member

Re: IOS transcoder/conferense bridge will not register with CCM

THANKS, I had the CFB and MTP after the MAC address

173
Views
0
Helpful
2
Replies