I'm using Anyconnect VPN with a 3825 and the VPN comes up and works well with data however, IP communicator is not fully functioning. Using CME 124-15.XZ1.
IPC registers and lines appear correctly. Services button works. Directory works. IPC is set to use the Anyconnect adapter.
When I attempt to make a call, not much happens. The speaker phone button lights green, but no dial-tone. No digits are dialed. VM button doesn't dial. Pressing line buttons will not take IPC off-hook.
All works great with IPSEC client.
Using the latest IPC release, did the same with the previous. Tried a couple different versions of Anyconnect too.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.