Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IP Communicator

I am using an IP Communicator softphone ver 2.1, after successfully registering to the Call Manager and made a call I have received an error message "not enough bandwidth". I am using Vista as my OS with my laptop. With my XP I haven't experienced this type of problem. Is it OS related or what other possible cause of this problem. Thanks

2 REPLIES
Bronze

Re: IP Communicator

Hi, where is located your laptop with the CIPC, in a brach office or in the HQ.

If it is in a brach office, what codec you are using for calls, g711 or g729?

Also, make sure that the Location configuration assigned to the CIPC has enough bandwidth for the calls. (a call to g711=80kbps, 1 call to g729=24kbps)

Hope this help

David

New Member

Re: IP Communicator

thanks, we adjust the location configuration and increase the bandwidth and that resolves the problem, thanks again.

229
Views
0
Helpful
2
Replies