Yes, we are running IPC on WinXPsp2. I also ran into an issue with the services button. When pressed, it would display what appeared to be the raw XML code instead of the list of subscribed services. It ended up being a VPN client issue. We use checkpoint and the security policy was blocking the file IPC needed to properly generate that window. We only had to disable the security policy, launch IPC, then re-enable the policy. Once IPC received the file the first time, it was good to go from that point forward. Not sure if that's the same issue, but I wasted a lot of time running around in circles trying to figure that one out.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...