10-18-2001 05:46 PM - edited 03-12-2019 12:56 PM
Would the COR be an option to force a 7960's prime line to access a specific dial peer on a 2611? The application is replacing a decrepit PBX that serves 8 users with IP Keyswitch. The current lines are OPX which will be replaced with VoIP. We want the extensions off the host location to show up at the 7960's and when a specific line is selected, that particular POTS peer is used. Any thoughts?
Many Thanks!
10-29-2001 04:29 PM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources at the online http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
11-05-2001 01:04 PM
You could use a PLAR configuration for the specific lines. Then when the user selects a given line the PLAR connection can be used to dial an access code for that particular pots peer.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: