IP Phone 7960 unable to tftp config from CM 3.0.11 server
I recently upgraded CM from 3.0.11 to 3.1.3a (spD) and the 7960 phones were upgraded to the new firmware (P300....400). Due to voice quality problems, I backed out to CM 3.0.11. However, I am now unable to change phone configurations. I am wondering if this is because the phones are still on the new firmware but the CM is now back on 3.0.11.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...