Hi, i'm installing a small cme3.3 system as a demo on my lab, but i've some problems whit the 7970 ip phone. I'm using 4 7960 phone in italian locale config, and these works fine, but the 7970 phone give me an "Error Updating Locale" error.
I have upload all the firmware files needed to the callmanager's router and configure the tftp server to send it to the phone.
This is the expected behavior because the Cisco 7970 IP phone is not supported by Cisco CallManager 3.3(4). A relevant patch must be installed before the Cisco CallManager is prepared to operate with these high-end phones.
This issue is tracked in Cisco bug ID CSCee28642. The fix is to install 3.3(4)es03 or later. Alternatively, you can install 3.3 Devpack 34.2 or later.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.