Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IP phone 7980

Hii experts,,

I have an issue with my phone 7980 when I try to make a call throught the PRI it is only ring once then busy tone.

My VGW is 2811 and the PRI configuration as below:

interface Serial0/0/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn incoming-voice voice

isdn bchan-number-order ascending

no cdp enable

voice-port 0/0/0:15

bearer-cap Speech

And I configure a voice calss codec with G711 and g729 codecs and applied it to the Voip dial peer.

PLZ note that the calls therougt VGW 3825 are working fine.

Thanks..

3 REPLIES
Anonymous
N/A

Re: IP phone 7980

What type of protocol is being used in the CCM setup for the gateway? MGCP or H323?

New Member

Re: IP phone 7980

H323

thanks

New Member

Re: IP phone 7980

Hii,,

Thanks for all .. I found a solution for thais problem, it just was a codec problem. I it is ok now..

Thankks..

520
Views
0
Helpful
3
Replies