Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ip phone dialing issue

Dear all

i have CUCM 7.0

when end users on my cisco ip phones want to dial some where the dialing digit method is one by one. on their ip phone LCS they see digitis one by one and for each digit they hear a beep until finish.

3 REPLIES

Re: ip phone dialing issue

May need bit more information to help you.

Is this happening to all or a particular group? do you have any one confifgured right you can then take a look at their partition and CSS to make sure you have it correct.

How about the actutal phone device, the rev and firmware sometimes a issue as well.

Good luck.

Baseer

New Member

Re: ip phone dialing issue

actually all of my ip phones are so.

the story is like this

when my users want dial somewhere before they press "new call" softkey they try to dial digit and when the digits finished then they push "DIAL" bottom.

so the phone will start dial but one by one digit..

Re: ip phone dialing issue

That clears up quite a bit thank you.

So do you have any phones (are these ip communicators) working or all the same issue?

Its quite the same setup as regular phone but this may sound like bandwidth issue too. How do they behave for incomming calls?

192
Views
0
Helpful
3
Replies